How to Cook Perfect Rice Every Time
Rice looks like the simplest thing in the kitchen, and it is also the easiest to get wrong. Mushy grains, a burnt bottom, or a pot that is somehow both undercooked and soggy usually come down to the same three mistakes: the wrong water ratio, peeking under the lid, and skipping the rest. This guide fixes all three, with exact ratios for the rices home cooks actually buy.
The only ratios you need
Most rice failures start with too much water. For long-grain white rice and basmati, use 1 part rice to 1.5 parts water by volume. Jasmine rice likes a little less, about 1 to 1.25, because the grain is softer. Short-grain sushi rice needs 1 to 1.2, and brown rice needs more water and far more time, roughly 1 to 2, for 40 to 45 minutes. Measure both the rice and the water in the same cup; guessing is how pots go wrong.
Rinsing matters more than most recipes admit. Rinse basmati and jasmine in cold water, swirling with your hand, until the water runs mostly clear, usually three or four changes. That washes off surface starch, which is what makes cooked rice gluey. Do not rinse rice you want to be sticky, like sushi rice after its initial wash, and never rinse enriched rice if the packet says not to, since the nutrients are in the coating.
The method, step by step
Put the rinsed rice and the measured cold water in a heavy pot with a tight lid and a pinch of salt. Bring it to a full boil over medium-high heat, then stir once, just once, to free any grains stuck to the bottom. Put the lid on, turn the heat to the lowest setting your stove allows, and leave it completely alone for 15 minutes for white rice, or 18 for basmati. Do not lift the lid. Steam is doing the cooking, and every peek lets it out.
When the time is up, take the pot off the heat and leave it, lid still on, for 10 minutes. This rest is not optional: the grains finish absorbing the last of the steam and firm up, which is what makes the difference between fluffy and wet. Then fluff with a fork, not a spoon, lifting from the bottom so you do not crush the grains.
Fixing the common failures
If the rice is mushy, you used too much water or stirred during cooking. Next time cut the water by two tablespoons per cup of rice and do not touch it while it cooks. Spread the mushy batch on a tray to cool and turn it into fried rice, where the texture no longer matters.
If the bottom burns while the top is still hard, your heat was too high or your lid does not seal. Use the smallest burner, the lowest flame, and a lid wrapped in a clean tea towel to catch condensation and improve the seal. If the rice is undercooked but the water is gone, sprinkle two tablespoons of hot water over the top, lid back on, and give it 5 more minutes on low heat.
Leftover rice is a food-safety matter, not just a texture one. Cool it within an hour, refrigerate it, and eat it within 24 hours. Reheat it until it is steaming hot all the way through, and never reheat the same rice twice.
Frequently asked questions
Should I soak basmati rice before cooking?
Yes, 20 to 30 minutes in cold water helps basmati cook evenly and grow longer. Drain it well before cooking, and reduce the water slightly since soaked grains already hold moisture.
Why is my rice sticky even though I rinsed it?
Usually the heat was too high, which breaks grains and releases starch, or the rice was stirred during cooking. Keep the heat at its lowest, stir only once before the lid goes on, and rest the pot for 10 minutes.
Can I cook rice without a lid?
You can, using the pasta method: boil it in plenty of salted water like pasta, drain when tender, then return it to the hot pot off the heat for 5 minutes to steam dry. It works well for basmati and long-grain rice.